Installed on TouringSEROW.
Wiring, for example, was done without hesitation, referring to information on Net. The rest of the process, such as the extra wiring, required Sense, and I managed to put it all together nicely, even though it was a bit of a puzzle.
When I was checking for any abnormalities at the end, to my surprise, Axel's rotation was stuck!
Apparently, the grips were longer than the OEM grips, and the grips were interfering with the handlebar attachment point on the TouringSEROW equipped hand guard.
It's got a corn expander, but...
There is no choice but to use WasherQuantity between Hand guard and Cone Expander.:1 Set of 2pc. was found and resolved successfully!
The actual Heater, as seen in the previous reviews, is quite warm, and Level 1 of 3 levels is about enough.
We are in a snowy area and don't ride in the winter, so it will be useful in early spring or late fall.
- Instock
124.36 EUR (21,450 JPY)
Informations de livraison
In Stock : 1 left, Ships within 24 hours.
Estimated arrival date around
Conforme
-
WR250R
07-17 (3D7H)* The heat spot on the right side is not on the fingertip but on the palm of the hand, so you may feel the temperature difference between the left and right side.
-
WR250R
07-17 (3D7J)*The heat spot on the right side is not on the fingertip but on the palm of the hand, so you may feel the temperature difference between the left and right side.
-
WR250RX
07-17 (3D71)*The heat spot on the right side is not on the fingertip but on the palm of the hand, so you may feel the temperature difference between the left and right side.
-
WR250RX
07-17 (3D72)*The heat spot on the right side is not on the fingertip but on the palm of the hand, so you may feel the temperature difference between the left and right side.
Voir tout
YAMAHA
Détail du produit
[Numéro de pièce du fabricant] Q5K-YSK-063-Y40
**Veuillez vous assurer de porter des gants lorsque vous utilisez des chauffe-poignées.
*Veuillez ne pas utiliser le réglage élevé du réchauffeur de poignée lorsque la température de l'air extérieur est de 20 degrés ou plus.
*Veuillez remplacer la poignée et cesser d'utiliser le chauffe-poignée si la poignée a été usée ou endommagée.
*La norme MT-07 est une spécification d'environ 10 % pour le papillon des gaz.
*Veuillez faire fonctionner le contrôleur SCR950 après le démarrage du moteur.
*Vous pouvez sentir la différence de température à gauche et à droite car la position du point chaud sur le côté gauche du XT 250/XG 250 n'est pas le bout du doigt mais le côté de la paume.
*Il nécessite un détendeur d'échappement à cône GH (Q5K-YSK-041-E16) séparément.
*Veuillez le préparer séparément pour l'adhésif en caoutchouc qui est nécessaire pour coller la poignée gauche au guidon..
Confortable et facile à prendre en main en hiver !
Conçu spécifiquement pour les véhicules Yamaha pour une installation facile sans modifier le câblage du véhicule.
[Aperçu du produit]
Conçu spécifiquement pour les véhicules Yamaha pour une installation facile sans modification du câblage du véhicule
La poignée chauffante de plus petit diamètre au monde
L'élément chauffant en acier inoxydable qui chauffe uniformément atteint une grande durabilité..
Réglages simples des sorties par bouton-poussoir à 3 niveaux : Hi, Mid et Lo (chaque niveau de production peut être modifié par paliers de 10 %)
Réglage automatique de la puissance du chauffage en fonction de la tension de la batterie.
Conception fiable avec protection de la batterie.
Prudence
* S'il y a un mode d'emploi inclus, il sera en japonais.
LIENS DES PAGES MODÈLES
- SEROW250
- SEROW250
- SEROW250
- SEROW250
- SEROW250
- SEROW250
- SEROW250
- SEROW250
- SEROW250
- SEROW250
- SEROW250
- SEROW250
- SEROW250
- SEROW250
- SEROW250
- SEROW250
- SEROW250
- SEROW250
- Tricker (XG250)
- Tricker (XG250)
- Tricker (XG250)
- Tricker (XG250)
- Tricker (XG250)
- Tricker (XG250)
- Tricker (XG250)
- Tricker (XG250)
- Tricker (XG250)
- Tricker (XG250)
- Tricker (XG250)
- Tricker (XG250)
- Tricker (XG250)
- WR250R
- WR250R
- WR250R
- WR250R
- WR250R
- WR250R
- WR250R
- WR250R
- WR250R
- WR250R
- WR250R
- WR250R
- WR250R
- WR250R
- WR250R
- WR250R
- WR250R
- WR250R
- WR250R
- WR250X
- WR250R
- WR250X
- WR250R
- WR250X
- WR250R
- WR250X
- WR250R
- WR250X
- WR250R
- WR250R
- WR250X
- WR250R
- WR250X
- WR250R
- WR250R
- WR250X
- XT250X
- XT250X
- XT250X
- XT250X
- MT-07 (FZ-07)
- MT-07 (FZ-07)
- MT-07 (FZ-07)
- MT-07 (FZ-07)
- MT-07 (FZ-07)
- MT-07 (FZ-07)
- MT-07 (FZ-07)
- MT-07 (FZ-07)
- MT-07 (FZ-07)
- MT-07 (FZ-07)
- MT-07 (FZ-07)
- MT-07 (FZ-07)
- MT-07 (FZ-07)
- MT-07 (FZ-07)
- MT-07 (FZ-07)
- XSR700
- XSR700
- XSR700
- MT-09 (FZ-09)
- MT-09 (FZ-09)
- MT-09 (FZ-09)
- MT-09 (FZ-09)
- MT-09 (FZ-09)
- MT-09 (FZ-09)
- MT-09 (FZ-09)
- MT-09 (FZ-09)
- MT-09 (FZ-09)
- MT-09 (FZ-09)
- XSR900
- XSR900
- XSR900
- XSR900
- XSR900
- BOLT C Spec
- BOLT C Spec
- BOLT C Spec
- BOLT C Spec
- BOLT C Spec
- BOLT C Spec
- SCR950
- SCR950
- XJR1300
- XJR1300
- XJR1300
- XJR1300
- XJR1300
- XJR1300
- XJR1300
- XJR1300
- XJR1300
- XJR1300
- XJR1300
- XJR1300
- XJR1300
- XJR1300
- XJR1300
- XJR1300
- XJR1300
- XJR1300
- XJR1300
- XJR1300
- XJR1300
- XJR1300
NOUVEAUX ARRIVAGES DE PIÈCES D'OCCASION POUR
NOUVEAUX ARRIVAGES DE PIÈCES D'OCCASION POUR
NOUVEAUX ARRIVAGES DE PIÈCES D'OCCASION POUR
Nouveaux arrivages de produits d'occasion
Nouveaux arrivages de produits d'occasion
Produits prêts à être expédiés depuis le stock
Avis des clients
Reviews with image
Fits:YAMAHA XJR1300 00-15 5EAP, YAMAHA XJR1300 00-15 5EA9, YAMAHA XJR1300 00-15 5EAG, YAMAHA BOLT-C(A) 15-16 (B339)*Please operate the controller after starting the engine because the grip warmer will not be powered unless the headlight is on., YAMAHA WR250R 07-17 (3D72)*The heat spot on the right side is not on the fingertip but on the palm of the hand
Apr 10, 2022
Fits:YAMAHA XJR1300 00-15 5EAP, YAMAHA XJR1300 00-15 5EA9, YAMAHA XJR1300 00-15 5EAG, YAMAHA BOLT-C(A) 15-16 (B339)*Please operate the controller after starting the engine because the grip warmer will not be powered unless the headlight is on., YAMAHA WR250R 07-17 (3D72)*The heat spot on the right side is not on the fingertip but on the palm of the hand
Oct 3, 2021
Here are my thoughts on the installation
It hasn't gotten cold yet, so this will be my impression of the installation, not the use!
This time, it was installed in SEROW250!
The most difficult part is to take out the Connector which connects Wiring and put it back in the original position.
this [Color] If you can clear it, the rest is easy.
Fits:YAMAHA XJR1300 00-15 5EAP, YAMAHA XJR1300 00-15 5EA9, YAMAHA XJR1300 00-15 5EAG, YAMAHA BOLT-C(A) 15-16 (B339)*Please operate the controller after starting the engine because the grip warmer will not be powered unless the headlight is on., YAMAHA WR250R 07-17 (3D72)*The heat spot on the right side is not on the fingertip but on the palm of the hand
Feb 14, 2021
Although the technology is a beginner, it is very easy to install and has excellent performance. It's not uncomfortable off-road, it's not broken. I think it's the right quality for the price.
View DetailFits:YAMAHA XJR1300 00-15 5EAP, YAMAHA XJR1300 00-15 5EA9, YAMAHA XJR1300 00-15 5EAG, YAMAHA BOLT-C(A) 15-16 (B339)*Please operate the controller after starting the engine because the grip warmer will not be powered unless the headlight is on., YAMAHA WR250R 07-17 (3D72)*The heat spot on the right side is not on the fingertip but on the palm of the hand
Nov 21, 2018
Recently it is essential equipment ? ? ?
Approximately 15 ° C after switching off (No gut w)
Recently it is almost indispensable equipment. I can not get on to no more Motorcycle ww
Honda's Sports Grip Heater also has Button's position at a discreet
It is good, but it is difficult to understand how many steps are in now.
Because Yamaha's Grip heater is a separate switch
It is good to see by checking where you are in three stages now.
Even though it is said to be Large, it is discreet and is attached to the root of Mirror
So it does not get in the way.
Fits:YAMAHA XJR1300 00-15 5EAP, YAMAHA XJR1300 00-15 5EA9, YAMAHA XJR1300 00-15 5EAG, YAMAHA BOLT-C(A) 15-16 (B339)*Please operate the controller after starting the engine because the grip warmer will not be powered unless the headlight is on., YAMAHA WR250R 07-17 (3D72)*The heat spot on the right side is not on the fingertip but on the palm of the hand
Oct 31, 2018
Large success quickly, it was correct and installed.
With this we can ride comfortably this winter as well.
I also considered the Type with Switch in Grip of Other Brand Product, but the product I used before was difficult to operate and it was hard to see the display, so this time I made it as a separate Yamaha OEM Product.
New Custom Articles
