Visière Latérale

It was fall when I first bought it. I didn't want to be cold due to the wind on my knees, so I bought it and wore it

After doing a thorough pre-treatment of degreasing etc Peel off the peeling paper and come forward while positioning "Ku Once the position is fixed, use a separately prepared moving tape to fix the corners of the "2" shape If you peel the release paper forward one at a time, it will stick nicely
It depends on the temperature, but it was a little cold when I installed it, and the shape of the tape was a little different from the outside After the installation, I used the Heat gun to suppress the inside of the same Visor I was able to secure it firmly in place by making sure that I had an adhesive surface to which it would be fixed with tape

By the way, the screw of the prevention of falling off is attached, but I didn't want to process the body and visor Fixed as unused
It's been over a year since I installed it and it's attached securely with only the included tape

The fit is pretty good, the wind on my knees is lessened, and it makes winter driving a lot easier If it's raining after Small, the area that gets wet while driving is reduced
It's also my personal opinion that, on a windy day, I'm not sure if I'm going to be able to run on a bridge or a bank The bike may be a little flaccid, but as long as you are aware of how well it fits with the bike, it won't be too much I have never felt fear We have a lot of work to do

I installed it in PCX 2016.
Summer was good but I headed for the winter season and my feet are a bit cold so I found this item when I checked the countermeasure
Easy to impress (Impressions) I will write
1. First of all, Quantity : Pair (for Left and Right) I also looked at the side OEM I want to see Exactly fit without any gaps.

2. Installation was unexpectedly easy, but the bottom treatment wiped the surface gently with a mild detergent and dried before installing

3. Protecting the surface Although it was stripping off and peeling off Seal, you need to be careful not to scratch it when peeling it off

4. I peeled a little strong Seal of adhesive and pushed it little by little to paste it on the examination, but I carefully stretched it so as not to be Gap

5. After installing One Side, it will float unless you hold it down enough - - - It is warning because it floats considerably
I pressed it firmly from top to bottom several times.

6. After finishing installing Both Sides, I checked the float by the final check and pull a little to see if it could peel off

Although installing a little care is necessary, it was able to install safely.

Although it is imp of running, it is impression of running lightly in the neighborhood, but although the hem of Pants was swinging with the wind until now it seems that there is a considerable fitting effect.

Since I am not running at high speed yet, there is no impression on that point, but I think whether it can be expected if it is this minute

This time it was written for Screw stopper for safety, but this time it was installation with adhesive tape, but if there is something to be off, I think whether you have to consider Screw stopping.

There was a PCX in First Model Type until now
I finally installed it because it was not in the Second Type Model

Fit feeling is preeminent and it will not last until Limit
Is it a good sea plum to say

Just as Double-sided Tape hits the part of the solid surface of Curve
It can be added immediately
Tapping screw is included but I did not install it
The Instruction Manual is also attached, and the installation method is also written

The wind at your feet will also weaken, and flow into the snake at the time of rain will also
Prevent. It seems to be active in winter