Bonne nouvelle pour les propriétaires de Zephyr 750 qui ont du mal à ouvrir et fermer leur siège ...
Cette partie est presque toujours la cause de la mauvaise ouverture et fermeture du siège..
Le cylindre de la serrure du siège est fait de résine, et un bras de fer déplace cette résine pour ouvrir et fermer la serrure du siège. Il est donc difficile d'ouvrir et de fermer la serrure du siège après de nombreuses années d'utilisation car les coins ont été réduits...
En particulier, si le siège est déformé par le traitement du siège, ou si la position de verrouillage du siège est légèrement modifiée lorsque vous passez à un siège externe, il faudra exercer une force plus importante que lorsque vous utilisez le siège d'origine, ce qui endommagera les coins de la résine...
Il y a une contre-mesure pour remplacer toute la serrure, mais comme vous devez remplacer toute la clé, vous aurez deux clés, une pour la clé principale et une pour le siège !
C'est une vraie plaie, n'est-ce pas ?
En outre, certaines pièces peuvent être discontinuées, selon l'année du modèle..
J'ai donc fabriqué cette pièce en aluminium usiné !
Si l'ouverture et la fermeture du siège vous préoccupent un peu, pourquoi ne pas le changer ?
Good news for the owners of ZEPHYR 750 with bad seat opening / closing.
This part is almost always the reason why the seat does not open and close properly.
The cylinder in the seat lock is made of resin, and an iron arm moves this resin to open and close the lock, so after many years of use, the corner of the cylinder will decrease and it will become difficult to open and close the lock.
Especially, if the seat is warped by the seat processing or the lock position is slightly changed when the seat is changed to the aftermarket one, the force will be applied more than when the stock one is used, and the corner of this resin will be damaged.
There is also a solution to replace the whole lock, but it means replacing the whole key, so you will have two keys, one for the main key and one for the seat!
It is troublesome, isn't it?
In addition, depending on the year, some parts may have been discontinued.
So this part is made out of machined aluminum!
If you are worried about the opening and closing of the seat, why don't you replace it?