- [How is it used?The Indicator Lamp was lost when the Headlight was replaced, so it was retrofitted.Was the one you received as per Image?It was just like the image.Was the installation difficult?It is...Lire la suite
- The meter on my Yamaha TW200 is broken, so as a replacement for it I used itThis kind of Speedometer comes from all kinds of manufacturers nowadays There are some mysterious super low prices on Yahoo ...Lire la suite
- It is installed in HORNET250HORNET250 is a 3-pole blinkerWiring for 2-wire only Enter the Indicator, but do not use theQuantity:Pair (for Left and Right) If you connect the wire as it is and wired, th...Lire la suite
- I recently purchased a pair of Kijima indicator lamp for customized bike. Apparently, good looking and easy to install. Water-proof when riding under the rain and strong light. Lire la suite
- I installed it on the Custom tw 200. The distance meter came mad quickly. As you use it, the speedometer has become somewhat fuzzy at high speeds.Lire la suite
- I bought it as an Indicator of Blinker, Neutral, High beam but compared with KITACO 's product, there is no Rubber lid on the lower side and LED is pulled out a bit. Once it goes out, it will come...Lire la suite
- As Blinker indicator, Right - Left two Font BlinkerWiring connected in parallel, Blinker blinks normally, but when this Indicator flashes GHOST 668 lit (It does not turn off) To do.Lire la suite
- It is my 4th time to purchase this item. Manufacturer is also reliable, and COSPA is also good. Because the brightness is just right, I purchase this item whenever I need an Indicator Lamp. Since LED ...Lire la suite
- The Mini meter that was attached to the Motorcycle purchased in second hand was Type? Which the distance meter switched between odo and trip in Digital, but the critical distance meter broke and did n...Lire la suite
- I purchased it as Repeat.Since this Indicator Lamp is an LED, it saves electricity, its brightness is bright and it is very easy to see.I am handy in Large Ki easy to install.Although it is commonplac...Lire la suite
- Since I wanted to convert Blinker back and forth into 4 LEDs, I bought it. Handling Instruction Manual is not included, but if you simply interrupt Wiring from Indicator light and connect to Earth it ...Lire la suite
- Since the Indicator of a VIRAGO250 has deteriorated least recently, it is a pure Indicator VOX. Processing -> paint application -> it has LED-ized.
Unlike the Indicator of an electric lamp, a col...Lire la suite - After attaching, it becomes about about 30-km Impression it ran.
the vehicles attached are set to SR400 (03 models) -- the subminiature Speedometer of POSH which was being used before exchanged from...Lire la suite - He bought this Meter for Bar-handle-izing of a CUB.
Since there was an Indicator, it thought that there was also no failure to erase, but even if it wired this Meter as it is in wiring of the pure CU...Lire la suite - Although it is thin yellow ? by the color as a picture, it is cheap than expected, is actually cheap, and is saved.
-- the case where appearance also worries an EngineOff with an Orange exactly -- ...Lire la suite - It is a good form like an Indicator.
-- thinking that it is not too bad and coming out -- -- it is ordinarily good.
Lire la suite - [Webike Monitor] Since the friend's Meter broke down, it exchanged.
Attachment in particular was satisfactory.
However, by one, since lighting is the touch which is mainly illuminating the lower hal...Lire la suite - Although purchased by judgment only by a Catalog, attachment was also easy and a cinch.
Lire la suite - The thickness of an attachment portion attaches a Washer and a Nut and is less than [ 6mm ].
Lire la suite - Although not indicated in detail, is yellow at the time of putting out lights, and it is orange at the time of lighting.
The thickness of the > attachment portion attaches a Washer and a Nut, and is...Lire la suite
THE LARGEST
SHOP IN JAPAN
EXCLUSIVE COUPONS,
SALE, DEALS
FAST, RELIABLE
SHIPPING