- Purchased for XJR-1300Chainfor Conversion.I don't know the front and back. installed based on the Line on the body side of the OEMSprocket. I think the thinner side is the body side.Lire la suite
- Used for GSXR-125.NORMAL428 If you want to change the Front side without changing the Size, XAM's Sprocket is the easiest way to do so.More economical than 415Conversion.Lire la suite
- I was able to purchase this product at a much lower price than the OEM Product. The product in the picture is a Type with holes, but the one I received was a Type without holes, so it may be good or b...Lire la suite
- This is a Repeat purchase. The material is a common steel sprocket, but the effect of 16 shifting is clearly visible. There is no machining as shown in the photo.Lire la suite
- Because I ride a motorcycle that is a reimported vehicle and is unpopular with JapanFOR JAPAN MODEL, I have been living my life as a rider, struggling to find the right size even for drivetrain parts....Lire la suite
- I bought this product for my 80? GAG, and the effect of FrontSprocket is very large, and the speed is clearly different after changing the size. However, since the clutch is NORMAL, it tends to slip e...Lire la suite
- 3 pointsQuantity:I replaced it with a setSince the Rear sprocket is XAM, the Front is also XAM.Lire la suite
- I wanted to lower the RPMs a bit more when using the highway.The OEM was F15R45, but I waved it to F16R44 Long.The embrace is not too tight, and the start is not as bad as expected, and the extension ...Lire la suite
- I changed from 14T to 15T because CB250R is NORMAL and it is Mild because of the hard 1st and 2nd gear donk and engine braking.It is very easy to handle.I think this could be NORMAL.Highways are also ...Lire la suite
- I have had my WR250X for about 35,000 km since I bought it new, and I thought it was about time for this one.The reason I chose it was because it was on special.I have used it for about 8,000 kilomete...Lire la suite
- It was a change from a 19-digit. I think the change was a good decision because the change in Torque is not so noticeable. In the picture of the product, there are 8 holes in the shaft which I think i...Lire la suite
- I bought it to change the Chain of YamahaSDR200 to 520Size and swing the reduction ratio to Long.Reason for exchange.SDROEM is 428 Size, which is not a problem if the OEM reduction ratio remains the s...Lire la suite
- Ordered and delivered where I forgot?When GSX400X was practicing figure-8 and panylon slalom in the Nipo-Kyo Riding School, I wanted to run in first gear in Normal, but I was too low geared, so I was ...Lire la suite
- I thought they were out of print and hard to find.I am relieved to hear that it is compatible with current vehicles and will be readily available for some time.Lire la suite
- First of all, BALI is terrible.Webig's product image shows a hole for the meat removal, but in reality, it is not there.And some modifications are required for PackageLabel. (Lol)Well, I don't really ...Lire la suite
- It really fits the crf250l. I am satisfied with the product. After replacing the small gear, the speed got a little faster.Lire la suite
THE LARGEST
SHOP IN JAPAN
EXCLUSIVE COUPONS,
SALE, DEALS
FAST, RELIABLE
SHIPPING